LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Cutaway 4.8 V >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Upper Control Arm Replacement >> Installation Procedure

Installation Procedure

  1. Install the upper control arm.
    Fig 1: Upper Control Arm, Bolts, Nuts & Adjustment Cams
    GM830508Courtesy of GENERAL MOTORS CORP.
  2. Install the upper control arm bolts.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the upper control arm nuts and the adjustment cams.

    Tighten:  Tighten the nuts to 175 N.m (129 lb ft).

    4. Fig 2: Upper Ball Joint & Retaining Nut
    GM830521Courtesy of GENERAL MOTORS CORP.
  4. Connect the upper control arm to the steering knuckle.
  5. Install the new upper ball joint retaining nut.

    Tighten:  Tighten the nut to 50 N.m (37 lb ft).

  6. Install the wheel drive shaft (4WD only). Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
    7. Fig 3: View Of Retaining Bolts For Brake Hose And Wheel Speed Sensor Brackets
    GM367084Courtesy of GENERAL MOTORS CORP.
  7. Install the retaining bolts for the brake hose and wheel speed sensor brackets.

    Tighten: 

    • Tighten the brake hose bracket to steering knuckle bolt to 10 N.m (88 lb in).
    • Tighten the brake hose bracket to upper control arm bolt to 10 N.m (88 lb in).

  8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  9. Remove the safety stands.
  10. Lower the vehicle.
  11. Check the wheel alignment. Refer to Measuring Wheel Alignment in Wheel Alignment.
scientia non olet · About LEMON Manuals