Installation Procedure
- Position the front seat assembly into the vehicle.
- Install the nuts (3).
Tighten: Tighten the nuts to 60 N.m (44 lb ft).
- Connect the electrical connector to the seat assembly, if equipped with power seat motors.
- Enable the SIR. Refer to SIR Disabling and Enabling Zone 3 or SIR Disabling and Enabling Zone 5 in SIR.
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.