LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Cutaway 4.8 V >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Entertainment System >> Repair Instructions >> Radio Replacement >> Installation Procedure

Installation Procedure

  1. Install the radio mounting bracket. Perform the following steps:
    1. Attach the HVAC harness to the radio mounting bracket with the clip.
      2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    2. Install the screws (2) in order to retain the radio mounting bracket (1) to the instrument panel carrier.

      Tighten:  Tighten the screws to 3 N.m (27 lb in).

      3. Fig 1: Installing Radio Mounting Bracket To Instrument Panel Carrier Retaining Screws
      GM639268Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical/audio and antenna cable connectors to the radio.
  3. Install the radio to the support bracket (1).
    4. Fig 2: Installing Radio To Support Bracket
    GM665518Courtesy of GENERAL MOTORS CORP.
  4. Align the radio locator tab into the support bracket locator hole.
  5. Install the radio screws (2).

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  6. Install the instrument cluster panel. Refer to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster in Instrument Panel, Gages, and Console.
  7. Calibrate the new radio assembly. Refer to Service Programming System (SPS) in Programming.
scientia non olet · About LEMON Manuals