LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Corvette Base, 2D Coupe, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Introduction) -- 5.7L >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure

Removal Procedure

    Fig 1: MAF/IAT Sensor Electrical Connector
    GM695482Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the mass airflow/intake air temperature (MAF/IAT) sensor electrical connector.
    2. Fig 2: Air Intake Duct Clamp At Throttle Body
    GM695483Courtesy of GENERAL MOTORS CORP.
  2. Loosen the air intake duct clamp at the throttle body.
  3. Release the air intake duct at the throttle body.
  4. Release the air intake duct from the upper support grommet studs.
  5. Disconnect the AIR hose from the air cleaner assembly.
  6. Release the air cleaner assembly with the grommets from the grommet mounting studs.
  7. Remove the air cleaner assembly.
  8. Remove the MAF/IAT sensor from the air cleaner assembly, if necessary.
scientia non olet · About LEMON Manuals