LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Classic >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Steering Wheel Nut
    GM442081Courtesy of GENERAL MOTORS CORP.
  1. Route the electrical connectors (4) through the steering wheel opening.
  2. Connect the electrical connector (4) to the steering column (3).
  3. Install the steering wheel on the steering column (3).
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the steering wheel nut (1) on the steering column (3).

    Tighten:  Tighten the nut to 37 N.m (27 lb ft).

  5. Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
  6. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals