LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Classic >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Disc Brake System) >> Repair Instructions >> Disc Brake Hardware Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Am and 2004 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Caliper Mounting Bolt, Bracket, Boot & Slid Pins
    GM695066Courtesy of GENERAL MOTORS CORP.
  1. Install the caliper pin boots (4) to the disc brake caliper mounting bracket.
  2. Install the caliper pins (5) to the disc brake caliper mounting bracket (3).
  3. Install the disc brake pad retainers (4) to the disc brake caliper bracket.
  4. Install the disc brake pads (5) to the disc brake caliper bracket.
  5. Install the disc brake caliper (2) to the mounting bracket.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the disc brake caliper bolts (1).

    Tighten:  Tighten the disc brake caliper bolts to 31 N.m (23 lb ft).

    Apply and release the brake pedal 3/4 stroke as many times as necessary in order to obtain a firm brake pedal.

scientia non olet · About LEMON Manuals