LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Classic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Wiper System And Washer System) >> Repair Instructions >> Wiper Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Am and 2004 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wiper Motor, Transmission & Screws
    GM347710Courtesy of GENERAL MOTORS CORP.
  1. Position the wiper motor to the wiper transmission.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the wiper motor screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

    3. Fig 2: Installing Wiper Transmission To Wiper Motor Crank Arm
    GM306515Courtesy of GENERAL MOTORS CORP.
  3. Using the J 39529  , install the wiper transmission to the wiper motor crank arm. See Special Tools and Equipment .
    4. Fig 3: View Of Wiper Drive System Module, Electrical Connector & Screws
    GM347709Courtesy of GENERAL MOTORS CORP.
  4. Position the wiper drive system module to the vehicle.
  5. Install wiper drive system module screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

  6. Connect the wiper motor electrical connector.
  7. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
scientia non olet · About LEMON Manuals