Installation Procedure

Fig 1: View Of Seat Adjuster & Bolts

Courtesy of GENERAL MOTORS CORP.

Position the seat into the vehicle.
Align the seat adjuster hooks to the openings in the floor pan.
Manually tilt the seat assembly at an angle in order to engage the hooks into the floor pan.
Place the seat back in a full upright position.
Connect the power seat electrical connector, if equipped.
On the drivers side connect the seat belt wiring harness.
Position the seat assembly forward in order to gain access to the adjuster bolts (1).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the front seat adjuster bolts (1).
Tighten: Tighten the bolts to 41 N.m (30 lb ft).