Test C: Charge Indicator Inoperative
- If diagnostic system check was not performed, perform ENGINE ELECTRICAL DIAGNOSTIC SYSTEM CHECK under ON-VEHICLE TESTING. If diagnostic system check was performed, go to next step.
- Turn ignition switch to RUN position. If battery charge indicator illuminates during 5 second bulb check, problem is intermittent. Check wiring and connections. If battery charge indicator does not illuminate during 5 second bulb check, go to next step.
- Test Red wire for a high resistance or open between generator harness connector terminal "B" and PCM harness connector C2 terminal No. 61. See WIRING DIAGRAMS . If problem does not exist, go to next step. If problem exists, repair as necessary. After repairs are complete, go to step 6 .
- Inspect PCM harness connector for poor connections. If problem does not exist, go to next step. If problem exists, repair as necessary. After repairs are complete, go to step 6 .
- Replace PCM. See REMOVAL & INSTALLATION article in ENGINE PERFORMANCE. Program PCM. After repairs are complete, go to next step.
- Operate system to verify repair. If system is not operating correctly, repeat test beginning at step 2 .