LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission Servicing >> Removal & Installation >> Vehicle Speed Sensor >> Removal

Vehicle Speed Sensor: Removal

  1. Raise and support the vehicle.
  2. Remove the right front tire and wheel assembly.
  3. Remove the right engine splash shield.
  4. Remove the vehicle speed sensor wiring harness connector.
  5. Remove the vehicle speed sensor bolt (9). See Fig 1 .
  6. Remove the vehicle speed sensor (10) from the extension case.
  7. Remove the "O" ring (11) from the vehicle speed sensor (10). See Fig 2 .
    NOTE: Handle the vehicle speed sensor (10) carefully.
  8. Inspect the vehicle speed sensor and "O" ring seal for the following:
    • Damaged connector.
    • Cracked housing.
    • Signs of rotor damage.
    • Cuts or nicks on the "O" ring seal (11).
Fig 1: Removing & Installing Vehicle Speed Sensor
G00087710Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Vehicle Speed Sensor "O" Ring
G00087711Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals