LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission Servicing >> Adjustments >> Park/Neutral Position Switch

Park/Neutral Position Switch

NOTE: If a new Park/Neutral Position (PNP) switch has been rotated and the pin is broken or if using an old PNP switch, adjust the PNP switch.
  1. Place the shift shaft in the Neutral position.
  2. Use the Park/Neutral Position Switch Alignment Tool (J-41545) to align the slots of the PNP switch to the Neutral position.
  3. Align the flats of the shift shaft to the flats in the PNP switch.
  4. Install the PNP switch to the mounting boss. See Fig 1 .
    NOTE: If the PNP switch bolt holes do not align with the mounting boss on the transaxle, verify that the shaft is in the Neutral position.
  5. Assemble the PNP switch mounting bolts loosely.
  6. Use the PNP switch alignment tool to align the PNP switch. See Fig 2 .
  7. Install the PNP switch mounting bolts. Tighten the PNP switch mounting bolts to specification. See TORQUE SPECIFICATIONS  .
Fig 1: Removing & Installing Park Neutral Position Switch
G00087690Courtesy of GENERAL MOTORS CORP.
Fig 2: Identifying Park/Neutral Switch Alignment Tool
G00087691Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals