Test Description
The numbers below refer to the step numbers in the diagnostic procedures.
- 2 - This step verifies that a failure condition is active.
- 4 - Introducing smoke in 15 second intervals may allow smaller leak areas to be more noticeable. When system is less pressurized, smoke will sometimes escape in a more condensed manner.
- 6 - This step verifies proper operation of the Fuel Tank Pressure (FTP) sensor.
- 7 - A normal operating FTP sensor should increase to more than 5 in.H2O and stop 6-7 in. H2O.
- 9 - This step tests the EVAP purge solenoid vacuum source between the EVAP purge solenoid and the intake manifold for restrictions or blockages.