Diagnostic Procedures
- Did you perform the Diagnostic System Check - Engine Controls? If yes, go to next step. If no, see DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS under SELF-DIAGNOSTIC SYSTEM.
- DTC P0107 or P0108 also set? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, go to next step.
- Inspect the exhaust system for modification of original installed parts or leaks. Repair the exhaust system as necessary if you locate a problem. Did you find and correct the condition? If yes, go to step 7. If no, go to next step.
- Inspect for a vacuum leak between EGR valve and intake manifold. Did you find and correct the condition? If yes, go to step 7. If no, go to next step.
- Remove EGR valve. Visually and physically inspect EGR pintle and EGR pintle for a leak or a restriction. Did you find and correct the condition? If yes, go to step 7. If no, go to next step.
- Remove EGR inlet pipe from exhaust manifold. Inspect manifold EGR ports and EGR inlet pipe for blockage caused by excessive deposits or other damage. Correct the condition as necessary if a problem is found. Did you find and correct the condition? If yes, go to next step. If no, see DIAGNOSTIC AIDS .
- Clear the DTCs with a scan tool. Turn ignition off for 30 seconds. Start engine. Operate the vehicle within the Conditions for Running DTC. See CONDITIONS FOR SETTING DTC . Does the DTC run and pass? If yes, go to step 2. If no, go to next step.
- Observe the stored information, Capture Info with a scan tool. Does the scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.