LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Tracker 2D Utility, RWD, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission Servicing >> Removal & Installation >> Shift Cable >> Installation

Shift Cable: Installation

  1. Install the select lever assembly.
  2. Install the select indicator assembly.
  3. Install the knob. Install the 2 knob screws.
  4. Place the manual shift lever in the LOW position.
  5. Install the shift select cable (4) into the shift select cable bracket at the transmission. See Figure .
  6. Secure the shift select cable (4).
  7. Install the shift select cable into the manual shift lever while moving the manual shift lever back to the Neutral position.
    NOTE: Do not fully tighten the lock nut.
  8. Secure the shift select cable with the select cable lock nut (3). Tighten the shift select cable lock nut to specification. See TORQUE SPECIFICATIONS  .
  9. Lower the vehicle. Make it possible to access both the manual selector and the manual shift lever.
  10. Install the shift select cable to the selector lever. See Figure .
  11. Secure the washer with the retaining clip.
  12. Inspect both ends of the shift select cable to ensure that no cable deflection exists.
  13. Lower the vehicle.
  14. Install the manual selector to the floor.
  15. Secure the manual selector to the floor with the 4 bolts. Tighten the manual selector bolts to specification. See TORQUE SPECIFICATIONS  .
  16. Install the shift indicator lamp (1).
  17. Install the shift lock solenoid electrical connector (3) under the carpet.
  18. Install the console box to the floor. Install the 4 screws (1, 3, 4 and 6) and the 2 plastic retaining clips. See Figure .
  19. Put the manual selector in the Park position.
  20. Connect the negative battery cable. Check for proper operation.
scientia non olet · About LEMON Manuals