LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Tracker 2D Utility, RWD, Automatic >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pressure Switch Replacement >> Installation Procedure

Installation Procedure

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the PSP switch (2) into the power steering pump (3).

    Tighten 

    1. Tighten the PSP switch to 27 N.m (20 lb ft).

  2. Connect the PSP switch electrical connector (1).
  3. Bleed the air from the power steering system. Refer to BLEEDING THE POWER STEERING SYSTEM   in Power Steering System.
    Fig 1: Installing PSP Switch From Power Steering Pump
    G01469158Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals