LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Suburban K2500, 6.0 U >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - Basic Diagnostic Procedures - 8.1L) >> Ignition Systems >> Electronic Ignition System >> Circuit Description

Circuit Description

WARNING: This page is about a different variant/trim than selected.

The electronic ignition system uses an individual ignition coil for each cylinder. The PCM controls ignition operation through 8 individual Ignition Control (IC) circuits. Each bank of 4 ignition coils is connected to PCM, power or ground by low reference, chassis ground, ignition 1 voltage circuits and appropriate IC circuit. PCM triggers an ignition coil by grounding appropriate IC circuit using information from Crankshaft Position (CKP) and Camshaft Position (CMP) sensors. The CMP sensor is located on top center rear of engine and CKP sensor is located on engine block, near starter. See Figure or Figure .

scientia non olet · About LEMON Manuals