LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Battery, Charging System & Starting System) >> Repair Instructions >> Generator Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
  2. If necessary, remove the engine sight shield. Refer to Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L Engines) or Engine Sight Shield Replacement (6.0L Engine w/RPOs Y91 and Z88) in Engine Mechanical - 4.8L, 5.3L, and 6.0L.
  3. Remove the generator cable from the generator, perform the following:
    1. Reposition the boot to expose the stud.
    2. Remove the generator cable nut.
    3. Remove the generator cable from the stud.
    4. Fig 1: View Of Generator Cable & Nut
    GM395686Courtesy of GENERAL MOTORS CORP.
  4. Open the positive cable junction block.
  5. Remove the generator cable nut.
  6. Remove the generator cable (2) from the junction block.
    7. Fig 2: View Of Battery Cables At Junction Block
    GM662521Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals