LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Battery, Charging System & Starting System) >> Repair Instructions >> Battery Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the battery insulator, if necessary.
  2. Install the battery.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    3. Fig 1: View Of Battery & Insulator
    GM662922Courtesy of GENERAL MOTORS CORP.
  3. Install the battery hold down retainer and bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  4. Install the front end diagonal brace and bolts.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    5. Fig 2: View Of Front End Diagonal Brace & Bolts
    GM662921Courtesy of GENERAL MOTORS CORP.
  5. Connect the positive battery cable.

    Tighten:  Tighten the bolt to 17 N.m (13 lb ft).

  6. Snap the positive battery cable cap closed.
    7. Fig 3: View Of Battery & Positive Battery Cable
    GM662504Courtesy of GENERAL MOTORS CORP.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
scientia non olet · About LEMON Manuals