LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> SSR Base >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Ignition Switch Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Identifying Key Alarm Connector At Ignition Lock Cylinder Case
    GM306267Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR CAUTION in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the steering wheel theft deterrent lock. Refer to Steering Wheel Theft Deterrent Lock Replacement .
  3. Rotate the key alarm connector (1) 90 degrees.
  4. Gently pull the key alarm connector (1) out of the ignition lock cylinder case assembly (2).
    5. Fig 2: Ignition Switch, Electronic Lock Module & J 42759
    GM664261Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the connector from the ignition switch assembly.
  6. Remove the wires encased in the ignition switch clip, which is located on the side of the ignition switch.
  7. Remove the ignition switch assembly (2) using J 42759  . See Special Tools .
scientia non olet · About LEMON Manuals