Installation Procedure

Fig 1: View Of Ignition Lock Cylinder Case Assembly & Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Align the ignition lock cylinder case assembly (1) with the steering column tilt head assembly.
Secure the ignition lock cylinder case assembly (1) to the steering column using 3 pan head tapping screws (2).

Tighten: Tighten the screws to 7 N.m (62 lb in).
Install the ignition switch assembly. Refer to Ignition Switch Replacement .
Install the turn signal cancel cam and upper bearing. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.