Removal Procedure

Fig 1: Removing Small Boot Retaining Clamp

Courtesy of GENERAL MOTORS CORP.

Remove the outer tie rod. Refer to Rack and Pinion Outer Tie Rod End Replacement .
Remove the rack and pinion gear. Refer to Power Steering Gear Replacement .

IMPORTANT: All boot parts must be replaced when replacing the inner tie rod.

Fig 2: Removing Large Boot Retaining Clamp

Courtesy of GENERAL MOTORS CORP.

Remove and discard the large seal retaining clamp (1) from the rack and pinion boot (2) with side cutters.

Fig 3: Pulling Rack & Pinion Boot From Gear

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Do not cut the end of the boot or place a screwdriver between boot and tie rod.

Firmly pull rack and pinion boot (1) from the gear.
Discard the rack and pinion boot (1).