LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> SSR Base >> Repair and Diagnosis >> Electrical >> Body Electrical >> Battery >> Repair Instructions >> Battery Positive Cable Replacement (Junction Block To Engine) >> Removal Procedure

Removal Procedure

  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the rear battery cover bolts and cover.
  3. Disconnect negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
  4. Lower the vehicle.
  5. Open the hood.
    6. Fig 1: View Of Battery Cables At Junction Block
    GM662521Courtesy of GENERAL MOTORS CORP.
  6. Remove the nut retaining the positive battery cable at the junction box.
    7. Fig 2: View Of Underhood Bussed Electrical Center Positive Cable Bolt
    GM847253Courtesy of GENERAL MOTORS CORP.
  7. Remove the bolt retaining positive cable to electrical center.
    8. Fig 3: View Of Generator Cable & Nut
    GM395686Courtesy of GENERAL MOTORS CORP.
  8. Remove the positive cable from rear of generator.
  9. Raise the vehicle.
    10. Fig 4: Removing/Installing Positive Cable Lead From Starter
    GM899617Courtesy of GENERAL MOTORS CORP.
  10. Remove the nut retaining positive cable to starter.
  11. Remove the positive cable assembly from wire looms.
  12. Remove the positive cable assembly from vehicle from the bottom of the vehicle.
scientia non olet · About LEMON Manuals