LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> SSR Base >> Repair and Diagnosis >> Electrical >> Body Electrical >> Battery >> Repair Instructions >> Battery Positive Cable Replacement (Battery To Junction Block) >> Installation Procedure

Installation Procedure

    Fig 1: View of Positive Batter Cable
    GM1232268Courtesy of GENERAL MOTORS CORP.
  1. Install the positive battery cable to vehicle.
  2. Lower the vehicle.
  3. Install the positive battery cable to wire looms under hood.
    4. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the positive cable and nut in the junction box.

    Tighten:  Tighten nut to 6 N.m (53 lb in).

  5. Close the hood.
  6. Raise the vehicle.
  7. Install the positive battery cable to the wire looms on top of the right side frame rail.
  8. Connect the negative and positive battery cables. Refer to Battery Negative Cable Disconnect/Connect Procedure .
    9. Fig 2: Identifying Rear Battery Cover & Bolts
    GM1231396Courtesy of GENERAL MOTORS CORP.
  9. Install the rear battery cover (2) and nuts (1).

    Tighten:  Tighten nuts to 10 N.m (89 lb in).

  10. Lower the vehicle.
scientia non olet · About LEMON Manuals