LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> SSR Base >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Repair Instructions >> Seat Cushion Frame Replacement - Front >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Seat Cushion Frame to Power Seat Adjuster Frame Nuts
    GM1200433Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the 4 nuts that secure the seat cushion frame to the power seat adjuster frame.

    Tighten:  Tighten the seat cushion frame mounting nuts to 24 N.m (18 lb ft).

  2. Install the seat cushion cover and pad. Refer to Seat Cushion Cover and Pad Replacement - Front .
    3. Fig 2: Identifying Recliner Assembly to Side of Seat Bolts
    GM1200427Courtesy of GENERAL MOTORS CORP.
  3. Install the 2 bolts securing the recliner assembly to each side of the seat.

    Tighten:  Tighten the seat recliner mounting bolts to 26 N.m (19 lb ft).

  4. Install the harness clip securing the SIR harness to the seat adjuster.
  5. Connect the lumbar electrical connector, if equipped.
  6. Connect the electrical connector to the seat back harness.
  7. Connect the seat back heating element electrical connector, if equipped.
    8. Fig 3: Identifying Seat Adjuster & Cable
    GM1200365Courtesy of GENERAL MOTORS CORP.
  8. Install the cable end from the seat adjuster (2) by inserting the ball though the round opening.
  9. Install the seat adjuster cable (1) to the seat adjuster.
  10. Install the seat belt buckle assembly through the slot in the seat cushion cover.
    11. Fig 4: Identifying Seat Belt Buckle Assembly & Bolt
    GM1200371Courtesy of GENERAL MOTORS CORP.
  11. Install the seat belt buckle to the seat with the bolt (2).

    Tighten:  Tighten the seat belt buckle bolt to 55 N.m (41 lb ft).

  12. Run the seat belt buckle electrical harness through the seat adjuster.
  13. Connect the electrical connector to the seat belt buckle.
    14. Fig 5: Identifying Seat Cover to Frame Push Pins
    GM1293229Courtesy of GENERAL MOTORS CORP.
  14. Install the rear seat cover flaps to the frame with the push pins (2).
    15. Fig 6: Identifying J-strip
    GM1200364Courtesy of GENERAL MOTORS CORP.
  15. Install the J-Strip (1) on the rear of the seat cover to the frame.
  16. Install the seat cushion outer trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  17. Install the front finish panel. Refer to Finish Panel Replacement - Front Seat - Front .
  18. Install the front seat assembly to the vehicle. Refer to Seat Replacement .
scientia non olet · About LEMON Manuals