Removal & Installation: Generator: Removal

NOTE: Generator does not require periodic lubrication. The rotor shaft is mounted on bearings. Each bearing contains a permanent grease supply. Periodically check mounting bolts for tightness, and drive belt tension. The drive belt is self-adjusting, within operating limits of tensioner. CS 130D generator is serviced as a complete unit.

1. Disconnect negative battery cable.
2. Remove drive belt from generator.
3. Place coolant recovery reservoir aside for access.
4. Remove bolts (1, 2, 3) from generator. See Fig 1 .
5. Disconnect electrical connector from generator.
6. Remove protective boot from generator output BAT terminal.
7. Remove generator output BAT terminal nut and remove positive battery lead from generator.
8. Remove generator.

Fig 1: Removing Generator (3.1L)

Courtesy of GENERAL MOTORS CORP.