LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2003 >> Impala Police >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Monitor System RECALIBRATION >> Using RDS Radio

Using RDS Radio

  1. Turn ignition switch to OFF position.
  2. Ensure all tire pressures are adjusted to the pressure recommended on tire pressure label.
  3. Turn ignition switch to ACC or ON position, with engine off.
  4. Turn the radio off.
  5. Press and hold the TUNE DISP button until "SETTINGS" is displayed.
  6. Press the SEEK PSCAN up or down arrows until "TIRE MON" is displayed.
  7. Press the 1 PREV or 2 NEXT button to enter the submenu. "RESET" will be displayed.
  8. Press the TUNE DISP button, A chime will sound and "DONE" will be displayed.
  9. Scroll until "EXIT" is displayed.
  10. Press the TUNE DISP button to exit the TPM reset mode. A chime will sound to verify exit.
  11. After resetting, the TPM system requires up to 30 minutes of straight line driving in each of the following speed ranges to complete calibration process:
    • 15-40 MPH (24-64 KM/H).
    • 40-70 MPH (64-113 KM/H).
    • 70-90 MPH (113-145 KM/H).
    NOTE: The EBCM learns tire pressure calibration for each speed range independently. In Monitor Mode 1, EBCM has only partially learned tire pressure calibration for speed range and has limited detection capability for a tire pressure condition. In Monitor Mode 2, EBCM has fully learned tire pressure calibration for speed range and has full detection capability for a tire pressure condition.
NOTE: Learning process does not need to be completed during a single trip.
scientia non olet · About LEMON Manuals