Removal Procedure

IMPORTANT: The 3-way catalytic converter is serviced by replacing the entire assembly. Always replace the gaskets when servicing the 3-way catalytic converter assembly. Never install the original gaskets.

Fig 1: View Of Catalytic Converter & Exhaust Manifold Pipe Stud Nuts

Courtesy of GENERAL MOTORS CORP.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Disconnect the heated oxygen sensor (HO2S) electrical connector.
Remove the exhaust manifold pipe stud nuts.

Fig 2: View Of Catalytic Converter Mounting Nuts

Courtesy of GENERAL MOTORS CORP.

Remove the catalytic converter nuts.

Fig 3: View Of Catalytic Converter Hangers

Courtesy of GENERAL MOTORS CORP.

Remove the catalytic converter hangers.
Remove the 3-way catalytic converter.
Remove the gasket from the exhaust pipe.
Remove the gasket from the exhaust manifold.
Clean and inspect the exhaust manifold and the exhaust pipe gasket mating surfaces.

Fig 4: HO2S At Catalytic Converter

Courtesy of GENERAL MOTORS CORP.

Remove the heated oxygen sensor (HO2S). Refer to HEATED OXYGEN SENSOR .