LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Venture Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 1355 (Power Steering System) >> Repair Instructions >> Power Steering Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the reservoir to the pump.
  2. Install the power steering pump pulley. Refer to POWER STEERING PULLEY REPLACEMENT   . 
  3. Install the pump to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the power steering pump bolts.

    Tighten 

    Tighten the power steering pump bolts to 34 N.m (25 lb ft).

    Fig 1: Installing Power Steering Pump Bolts
    G01482910Courtesy of GENERAL MOTORS CORP.
  5. Install the return hose to the pump. Refer to POWER STEERING RETURN HOSE REPLACEMENT   . 
    Fig 2: Installing Return Hose To Pump
    G01482911Courtesy of GENERAL MOTORS CORP.
  6. Install the pressure hose to the pump. Refer to POWER STEERING PRESSURE HOSE REPLACEMENT   . 
  7. Install the drive belt. Refer to DRIVE BELT REPLACEMENT  in Engine Mechanical - 3.4L.
  8. Fill the power steering system. Refer to CHECKING AND ADDING POWER STEERING FLUID   . 
  9. Bleed the power steering system. Refer to BLEEDING THE POWER STEERING SYSTEM   . 
  10. Inspect the system for leaks. Refer to POWER STEERING SYSTEM TEST PROCEDURE   . 
    Fig 3: Installing Pressure Hose To Pump
    G01482912Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals