Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Nut At Rear Of Front Fender Liner

Courtesy of GENERAL MOTORS CORP.

Position the fender liner to the fender, over the stud and behind the rocker molding.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the nut to the stud at the rear of the front fender liner.
Tighten: Tighten the front fender liner stud nut to 4 N.m (35 lb in).

Fig 2: Front Fender Liner To Front Bumper Fascia Screws

Courtesy of GENERAL MOTORS CORP.

Install the screws to the front fender liner at the front bumper fascia.
Tighten: Tighten the front fender liner to front bumper fascia screws to 2 N.m (18 lb in).

Fig 3: Front Fender Liner Screws

Courtesy of GENERAL MOTORS CORP.

Install the screws to the front fender liner.
Tighten: Tighten the front fender liner screws to 2 N.m (18 lb in).
Using a new plastic rivet, install the plastic rivet to the rocker panel and front fender liner, if equipped.

Fig 4: Bolt At Front Tab Of Front Fender Liner

Courtesy of GENERAL MOTORS CORP.

Install the bolt to the front tab of the front fender liner at the lower engine compartment side rail.
Tighten: Tighten the front fender liner to rear of fender bolt to 7 N.m (61 lb in).

Fig 5: Front Bumper Fascia Extension Plastic Rivets

Courtesy of GENERAL MOTORS CORP.

Using new plastic rivets, install the plastic rivets to the front fascia extension corner and front fender liner.