LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 586 (HVAC Systems - Automatic) >> Repair Instructions >> Compressor Replacement (3.4L) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
  2. Release the drive belt tension by lifting or rotating the drive belt tensioner with a breaker bar.
  3. Remove the drive belt from the A/C compressor pulley and position the drive belt aside.
  4. Slowly release the tension from the drive belt tensioner and remove the breaker bar.
  5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  6. Remove the splash shield from the right side of the engine. Refer to Splash Shield Replacement - Engine - Right in Body Front End.
  7. Remove the lower air deflector. Refer to Radiator Air Baffle and Deflector Replacement - Lower in Engine Cooling.
  8. Remove the A/C compressor hose bolt.
  9. Disconnect the A/C compressor hose from A/C compressor.
  10. Disconnect the electrical connector from the A/C compressor.
  11. Remove and discard the sealing washers.
    12. Fig 1: A/C Compressor & Bolts (3.4L)
    GM277918Courtesy of GENERAL MOTORS CORP.
  12. Remove the lower mounting bolt.
  13. Remove the 2 upper mounting bolts.
  14. Remove the A/C compressor from the vehicle.
    15. IMPORTANT: Replacement compressors are shipped without PAG oil
  15. If replacing the compressor, balance the compressor oil. Refer to Compressor Oil Balancing .
scientia non olet · About LEMON Manuals