LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 586 (HVAC Systems - Automatic) >> Repair Instructions >> Blower Motor Resistor Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Blower Motor Resistor
    GM295304Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Align the blower motor control processor forward retaining slots onto screws and seat the blower motor control processor against the HVAC module.
  1. Install the blower motor resistor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the rear screw to the blower motor resistor.

    Tighten:  Tighten all screws to 1.5 N.m (13 lb in).

    3. Fig 2: Blower Motor & Electrical Connector
    GM295327Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the blower motor.
    4. Fig 3: Blower Motor Resistor Electrical Connector
    GM295302Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the blower motor resistor.
  5. Install the right side instrument panel insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals