LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 586 (HVAC Systems - Automatic) >> Repair Instructions >> Air Distribution Duct Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Right Air Distribution Duct & Retaining Bolts
    GM507699Courtesy of GENERAL MOTORS CORP.
  1. Install the right air distribution duct to the cross vehicle beam.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the right air distribution duct bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Install the right I/P fuse junction block.
    4. Fig 2: Panel Air Duct, Retaining Screw & Retaining Bolts
    GM812951Courtesy of GENERAL MOTORS CORP.
  4. Install the panel air distribution duct to the cross vehicle beam.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the panel air distribution duct screw (1).

    Tighten:  Tighten the screw (1) to 1.8 N.m (16 lb in).

  6. Install the panel air distribution duct bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  7. Install the I/P lower trim panel. Refer to Instrument Panel (I/P) Trim Panel Replacement - Lower (Impala) or Instrument Panel (I/P) Trim Panel Replacement - Lower (Monte Carlo) in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals