LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 573 (Bumper System) >> Repair Instructions >> Fascia Support Bracket Replacement - Front Upper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fascia Support Bracket
    GM457296Courtesy of GENERAL MOTORS CORP.
  1. Align the center support bracket to the hood latch center support and to the upper support.
  2. Install the bolts to the hood latch center support and hand tighten.
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the bolt to the front bumper fascia upper support.

    Tighten: 

    1. Tighten the bolt to the front bumper fascia upper support to 10 N.m (89 lb in).
    2. Tighten the bolts to the hood latch center support to 10 N.m (89 lb in).

  4. Install the upper radiator air baffle. Refer to Radiator Air Baffle and Deflector Replacement - Upper in Engine Cooling.
  5. Close the hood.
scientia non olet · About LEMON Manuals