Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

Fig 1: Front Bumper Fascia Extension Plastic Rivets

Courtesy of GENERAL MOTORS CORP.

Drill out the plastic rivets from the front bumper fascia extension corner to the front fender liner.
Remove the lower fascia support. Refer to Fascia Support Replacement - Front Bumper Lower (Impala) or Fascia Support Replacement - Front Bumper Lower (Monte Carlo) .

Fig 2: Front Fender Liner To Front Bumper Fascia Screws

Courtesy of GENERAL MOTORS CORP.

Remove the front fender liner to front bumper fascia screws.

Fig 3: Fascia Extension Spring Clips

Courtesy of GENERAL MOTORS CORP.

Remove the spring clips from the fascia extension.

Fig 4: Fascia Extension

Courtesy of GENERAL MOTORS CORP.

Remove the fascia extension.