Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fascia Extension

Courtesy of GENERAL MOTORS CORP.

Position the fascia extension to the fascia.

Fig 2: Fascia Extension Spring Clips

Courtesy of GENERAL MOTORS CORP.

Install the spring clips starting at the center of the fascia extension and working outward.

Fig 3: Front Fender Liner To Front Bumper Fascia Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the screws to the front fender liner at the front of the front bumper fascia.
Tighten: Tighten the front fender liner to fascia screws to 2 N.m (18 lb in).

Fig 4: Front Bumper Fascia Extension Plastic Rivets

Courtesy of GENERAL MOTORS CORP.

Using new plastic rivets, install the 2 plastic rivets to the front bumper fascia extension corner and front fender liner.
Install the lower fascia support. Refer to Fascia Support Replacement - Front Bumper Lower (Impala) or Fascia Support Replacement - Front Bumper Lower (Monte Carlo) .
Lower the vehicle.