LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 562 (Body Front End) >> Repair Instructions >> Hood Latch Release Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Hood Release Cable
    GM456708Courtesy of GENERAL MOTORS CORP.
  1. Tie the wire or string to the hood release cable.
  2. Install the hood release cable to the vehicle.
  3. Pull the hood release cable through the dash until the grommet is seated in the hole.
    4. Fig 2: View Of Hood Latch Cable & Grommet
    GM363889Courtesy of GENERAL MOTORS CORP.
  4. Install the grommet into the dash.
    5. Fig 3: Side Rail Hood Release Cable Retainers
    GM456711Courtesy of GENERAL MOTORS CORP.
  5. Install the hood release cable retainers to the engine compartment side rail.
    6. Fig 4: Upper Tie Bar Hood Release Cable Retainers
    GM456710Courtesy of GENERAL MOTORS CORP.
  6. Install the hood release cable retainers to the upper tie bar.
    7. Fig 5: Hood Release Cable
    GM456709Courtesy of GENERAL MOTORS CORP.
  7. Connect the hood release cable to the hood latch.
  8. Install the air cleaner.
  9. Install the hood release cable to the hood release handle. Refer to Hood Latch Release Handle Replacement .
  10. Install the carpet back to its original position.
  11. Remove the block from the hood latch.
  12. Inspect the hood release cable for proper operation before closing the hood.
  13. Close the hood.
scientia non olet · About LEMON Manuals