LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 562 (Body Front End) >> Repair Instructions >> Fender Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply tape to corners of panel and adjacent surfaces to help prevent paint damage.
  2. Remove the hood. Refer to Hood Replacement .
  3. Remove the hood hinge. Refer to Hood Hinge Replacement .
  4. Remove the front fender liner. Refer to Front Fender Liner Replacement .
  5. Remove the front fender sound insulator. Refer to Fender Sound Insulator Replacement - Front .
  6. Remove the washer solvent container from the right fender. Refer to Washer Solvent Container Replacement in Wipers/Washer Systems.
  7. Remove the rocker panel molding. Refer to Molding Replacement - Rocker Panel (Impala) or Molding Replacement - Rocker Panel (Monte Carlo) in Exterior Trim.
  8. Remove the body side molding, if required. Refer to Molding Replacement - Body Side in Exterior Trim.
    9. Fig 1: Fender To Door Hinge Pillar Bolt
    GM363642Courtesy of GENERAL MOTORS CORP.
  9. Remove the bolts from the fender at the door hinge pillar.
    10. Fig 2: Fender To Rocker Panel Bolts
    GM363613Courtesy of GENERAL MOTORS CORP.
  10. Remove the bolts from the fender at the rocker panel.
    11. Fig 3: Fender To Front Compartment Side Rail Bolts
    GM363624Courtesy of GENERAL MOTORS CORP.
  11. Remove the bolts from the fender at the front compartment side rail.
    12. Fig 4: Fender To Rocker Panel Bolts
    GM363644Courtesy of GENERAL MOTORS CORP.
  12. Remove the bolts from the fender at the lower engine compartment side rail.
  13. Remove the fender from the vehicle.
scientia non olet · About LEMON Manuals