Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Install the power seat switch to the front seat cushion trim panel, if equipped. Refer to Seat Switch Replacement - Power .
Install the lumbar control switch to the front seat cushion trim panel, if equipped. Refer to Lumbar Switch Replacement .
Install the heated seat switch to the front seat cushion trim panel, if equipped. Refer to Heated Seat Switch Replacement - Front (Impala) or Heated Seat Switch Replacement - Front (Monte Carlo) .

Fig 1: Front Seat Cushion Trim Panel & Retaining Clips

GM522216

Courtesy of GENERAL MOTORS CORP.

Install the seat cushion trim panel, pressing in until the two retaining clips are fully seated.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Fig 2: Front Cushion Trim Panel Rear Screws

GM522222

Courtesy of GENERAL MOTORS CORP.

Install the front cushion trim panel rear screws.
Tighten: Tighten the front seat cushion trim panel screws to 3 N.m (27 lb in).

Fig 3: Installing Front Seat Cushion Trim Panel Push-In Retainer

GM522223

Courtesy of GENERAL MOTORS CORP.

Install the push-in retainer to the front of the front seat cushion trim panel, pressing into place until fully seated.

Fig 4: Front Seat Lumbar Knob

GM522225

Courtesy of GENERAL MOTORS CORP.

Install the front seat lumbar knob, pressing into place until fully seated.

Fig 5: Front Seat Back Recliner Handle

GM522228

Courtesy of GENERAL MOTORS CORP.

Install the front seat back recliner handle, pressing into place until fully seated.