LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 540 (Lighting Systems) >> Repair Instructions >> High Mounted Stop Lamp Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: High Mounted Stoplamp Electrical Connector
    GM458181Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector to the high mounted stoplamp.
    2. Fig 2: High Mounted Stoplamp
    GM458174Courtesy of GENERAL MOTORS CORP.
  2. Install the high mounted stoplamp pressing in until the retainers are fully seated.
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the screws to the high mounted stoplamp.

    Tighten:  Tighten the high mounted stoplamp screws to 2 N.m (18 lb in).

    4. Fig 3: High Mounted Stoplamp Bracket
    GM669080Courtesy of GENERAL MOTORS CORP.
  4. Install the high mounted stoplamp bracket.
  5. Install the screw to the high mounted stoplamp bracket.

    Tighten:  Tighten the high mounted stoplamp bracket screw to 2 N.m (18 lb in).

  6. Close the rear compartment.
scientia non olet · About LEMON Manuals