LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 537 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Multifunction Alarm Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Radio Delete Plate & Screws
    GM697548Courtesy of GENERAL MOTORS CORP.
  1. Install the multifunction alarm module to the instrument panel by pressing in place until fully seated.
  2. Connect the electrical connector to the multifunction alarm module.
    3. Fig 2: Multifunction Alarm Module & Electrical Connector
    GM697546Courtesy of GENERAL MOTORS CORP.
  3. Install the radio delete plate to the instrument panel.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the screws to the radio delete plate.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  5. Install the instrument cluster trim panel. Refer to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Impala)  or Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Monte Carlo) .
scientia non olet · About LEMON Manuals