Installation Procedure
- Position the radio to the instrument panel.
- Connect the instrument panel wiring harness connector and the antenna cable connector to the radio.
Important: If the radio locator tab is difficult to align to the instrument panel locator opening, pull the radio toward you and reposition the antenna cable.
- Install the radio to the instrument panel. Align the radio locator tab to the instrument panel locator opening while pressing the radio into the instrument panel until fully seated.
- Install the screws to the radio. Tighten the radio screws to 2 N.m (18 lb in).
- Install the instrument panel cluster trim plate.
- Preform the radio set up procedure for new and reinstalled radios. Refer to Radio Setup .