Installation Procedure
- Install the cooling fan shroud.
- Install the cooling fan shroud clip to the top of the radiator. Apply pressure in order to completely engage the clip onto the radiator.
- Install the cooling fan shroud bolts. Tighten the bolts to 10 N.m (89 in lbs).
- Connect the cooling fan shroud electrical connectors.
- Install the cooling fan heat shields.
- Install the radiator upper support brackets and bolts that hold the fan shroud. Tighten the bolts to 10 N.m (89 in lbs).
- Install the air cleaner assembly.
- Install the PCM harness on to the fan shroud clip.
- Install the radiator inlet hose to the radiator.
- Install the left front fender upper diagonal brace.
- Install the right and left engine mount struts. Refer to the following procedures:
- Raise the vehicle.
- Install the transmission oil cooler lines to the retainers at the bottom of the cooling fan shroud.
- Lower the vehicle.
- Fill the cooling system. Refer to Draining & Filling Cooling System .
- Connect the negative battery cable.
- Inspect for proper operation.