LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Corvette Z06 >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> Diagnostic Information >> DTC P0563 >> Testing

DTC P0563: Testing

  1. Did you perform the DIAGNOSTIC SYSTEM CHECK - ENGINE ELECTRICAL? If so, go to next step. If not, go to DIAGNOSTIC SYSTEM CHECK - ENGINE ELECTRICAL  .
  2. Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, observe the IGNITION 1 SIGNAL parameter in the PCM data list. Does the scan tool indicate that the Ignition 1 Signal parameter is less than the specified range of 16.0V? If so, go to step  4 . If not, go to next step.
  3. Measure the voltage at the battery and compare it with the Ignition 1 Signal parameter in the PCM data list. Are the battery voltage and PCM Ignition 1 readings different by more than the value specified of 0.5V? If so, go to next step. If not, go to TEST A: CHARGING SYSTEM TEST .
  4. Replace the PCM. See POWERTRAIN CONTROL MODULE . After replacement is complete, go to next step.
  5. Review and record the scan tool Fail Records data. Use the scan tool in order to clear the DTC(s). Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. See CONDITIONS FOR RUNNING THE DTC  . Using the scan tool, observe the SPECIFIC DTC INFORMATION for DTC P0563 until the test runs. Does the scan tool indicate that DTC P0563 failed this ignition? If so, go to step  2 . If not, then system is okay.
scientia non olet · About LEMON Manuals