LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Corvette Z06 >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> Diagnostic Information >> DTC B2282 >> Testing

DTC B2282: Testing

  1. Did you perform the DIAGNOSTIC SYSTEM CHECK - ENGINE ELECTRICAL? If so, go to next step. If not, go to DIAGNOSTIC SYSTEM CHECK - ENGINE ELECTRICAL  .
  2. Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, observe BATTERY 1 parameter in the LDCM data list. Does the scan tool indicate that the Battery 1 parameter is within the specified range of 8.5-16.3V? If so, go to INTERMITTENTS  . If not, go to next step.
  3. Test for a high resistance in the battery 1 positive voltage circuit of the LDCM. Did you find and correct the condition? If so, go to step  6 . If not, go to next step.
  4. Inspect for poor connections at the harness connector of the LDCM and the instrument panel electrical center. Did you find and correct the condition? If so, go to step  6 . If not, go to next step.
  5. Replace the LDCM. After replacement is complete, go to next step.
  6. Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for setting the DTC as specified in the supporting text. See CONDITIONS FOR SETTING THE DTC  . Does the DTC reset? If so, go to step  2 . If not, then system is okay.
scientia non olet · About LEMON Manuals