Installation Procedure
NOTE:
Use care when removing or installing the headliner. Excessive bending will damage the headliner.
- Position the headliner in the vehicle.
- Use adhesive tape GM P/N 9986080 in order to connect the electrical harness to the headliner.
- Connect the connector to the rear view mirror and the body electrical harness.
- Connect the connector to the sunroof electrical harness.
- Install the push-in retainers (3) to the headliner.
- Install the dome lamp. Refer to DOME LAMP REPLACEMENT .
- Install the sunroof power switch, if equipped.
- Install the finish lace to the sunroof opening trim, if equipped.
- On the coupe install the rear quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter .
- On the sedan install the following:
- 10.1. Install the upper rear quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter Upper .
- 10.2. Install the center pillar upper trim panel. Refer to Trim Panel Replacement - Upper Center Pillar .
- Install the windshield upper garnish molding. Refer to Garnish Molding Replacement - Windshield Pillar .
- Install the coat hooks. Refer to Coat Hook Replacement (Sedan) or Coat Hook Replacement (Coupe) .
- Install the sunshades. Refer to Sunshade Replacement .
- Install the assist strap, if equipped. Refer to Assist Strap Replacement .