Diagnostic Procedures
- Did you perform the Diagnostic System Check-Engine Controls? If yes, go to next step. If no, see DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS under SELF-DIAGNOSTIC SYSTEM.
- Replace the TAC module. See appropriate REMOVAL, OVERHAUL & INSTALLATION article. After repairs, go to next step.
- Clear the DTCs with a scan tool. Turn OFF the ignition. Start the engine. Operate the vehicle within the Conditions for Running DTC. Does the DTC run and pass? If yes, go to next step. If no, go to step 2.
- Observe the stored information, Capture Info with a scan tool. Does the scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.
NOTE:
If any other DTCs are set, refer to the appropriate DTC first for further diagnosis. See DIAGNOSTIC TROUBLE CODE DEFINITIONS .