LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Tracker 2D Utility, RWD, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Self-Diagnostics >> Diagnostic Tests >> DTC P1451: Barometric Pressure Sensor Performance >> Diagnostic Procedures

Diagnostic Procedures

  1. Perform diagnostic system check. See POWERTRAIN DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM. After performing diagnostic system check, go to next step.
  2. Check DTCs. If DTC P1408 is set, diagnose DTC. Go to DTC P1408  . If DTC P1408 is not set, go to next step.
  3. Using scan tool, clear DTCs. Operate vehicle within FREEZE FRAME conditions. Retrieve DTCs. If this DTC resets, go to next step. If this DTC does not reset, see DIAGNOSTIC AIDS  .
  4. Observe MAP sensor parameter on scan tool. If scan tool displays 100 kPa, go to next step. If scan tool does not display 100 kPa, see DIAGNOSTIC AIDS  .
  5. Turn ignition off. Replace PCM. Perform PCM relearn procedure. See POWERTRAIN CONTROL MODULE  under PROGRAMMING. After replacing PCM, go to next step.
  6. Turn ignition on, with engine off. Using scan tool, clear DTCs. Turn ignition off for 30 seconds. Start engine and operate vehicle within the conditions for running the DTC. See CODE ENABLE CRITERIA  . If DTC runs and passes, go to next step. If DTC resets, go to step  2 .
  7. Using scan tool, observe stored information and Capture Info. If scan tool displays any undiagnosed DTCs, diagnose affected DTCs. See DIAGNOSTIC TROUBLE CODE DEFINITIONS  . If no other DTCs are displayed, system is okay.
scientia non olet · About LEMON Manuals