Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the accelerator pedal to the steering column support bracket.
Refer to FASTENER NOTICE in Cautions and Notices.
- Install the accelerator pedal mounting bolts.
Tighten
Tighten the accelerator control assembly to floor fasteners to 20 N.m (15 lb ft).
- Connect the APP sensor harness connector.
- With the vehicle not in reduced engine power, turn ON the ignition, with the engine OFF. Test for proper throttle opening and closing range by operating the accelerator pedal and monitoring the throttle angles using a scan tool. The accelerator pedal should operate freely without binding between full closed throttle and wide open throttle (WOT).
- Inspect the carpet fit under the accelerator pedal.
- Install the left IP lower closeout insulator panel.
IMPORTANT:
Always use a torque wrench in order to obtain the proper torque.