LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Suburban C1500 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 4.8L, 5.3L, And 6.0L - Repair Instructions >> Repair Instructions >> Idle Air Control Valve Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Measuring Distance Between IAC Valve Pintle & Mounting Flange
    GM17065Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:

    If installing a new IAC valve, be sure to replace the IAC valve with an identical part. The pintle shape of the IAC valve and the diameter of the IAC valve are designed for the specific application.

  1. Measure the distance between the tip of the IAC valve pintle and the mounting surface (1). If the distance is more than 28 mm (1.1 in) use finger pressure to slowly retract the pintle. The force required to retract the pintle of a new valve does not cause damage to the valve.
    2. Fig 2: View Of TP Sensor, IAC Valve & Components
    GM356448Courtesy of GENERAL MOTORS COMPANY
  2. Lubricate the IAC valve O-ring (2) with clean engine oil.
  3. Install the IAC valve O-ring (2) on the IAC valve (3).
  4. Install the IAC valve (3).
  5. Apply LOCTITE 262 to the IAC valve attaching screw threads if necessary.

    Refer to FASTENER NOTICE in Cautions and Notices.

  6. Install the IAC valve attaching screws (4).

    Tighten 

    Tighten the screws to 3 N.m (27 lb in).

    7. Fig 3: View Of TP Sensor & IAC Valve Electrical Connectors
    GM389028Courtesy of GENERAL MOTORS COMPANY
  7. Connect the IAC valve electrical connector.
  8. Perform the idle learn procedure. Refer to Throttle/Idle Learn .
scientia non olet · About LEMON Manuals