LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> Electrical >> Charging Systems >> Diagnostic Tests >> DTC B2282: Left Door Control Module Battery 1 Circuit

DTC B2282: Left Door Control Module Battery 1 Circuit

  1. If diagnostic system check was not performed, perform ENGINE ELECTRICAL DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM. If diagnostic system check was performed, go to next step.
  2. Connect scan tool to Data Link Connector (DLC). DLC is located below left side of instrument panel. Turn ignition switch to RUN position. Using scan tool, observe Battery 1 parameter in Left Door Control Module (LDCM) data list. If scan tool indicates Battery 1 parameter is 9.0-16.3 volts, problem is intermittent. Check wiring and connections. If scan tool does not indicate Battery 1 parameter is 9.0-16.3 volts, go to next step.
  3. Test LDCM Battery 1 positive voltage circuit for high resistance. If problem exists, repair as necessary. After repair, go to step  6 . If problem does not exist, go to next step.
  4. Inspect LDCM harness connector for poor connections. If problem exists, repair as necessary. After repair, go to step  6 . If problem does not exist, go to next step.
  5. Replace LDCM. Reprogram LDCM, if necessary. See POWER DOOR LOCKS - CORVETTE article in ACCESSORIES & EQUIPMENT. After repair, go to next step.
  6. Using scan tool, clear DTCs. Start engine. If DTC B2282 resets, repeat test beginning at step  2 . If DTC B2282 does not reset, system is okay.
scientia non olet · About LEMON Manuals